A6061 Rope Pulley INSTRUCTIONS FOR USE

Setup

The A6061 Rope Pulley must be used with a large carabiner, 100-120mm minimum (not included).

If you do not have a lanyard stopper already on the rope:

1. Locate the end of the rope where the bottom weight will attach.
2. Pull the end of the rope under the metal pin (through the handle) and underneath the rope stopper (rope stopper should be in an open position*).
3. Continue feeding the rope under the rope stopper and out through the other side.
4. Test the pulley on land before using it in the water.

If you already have a lanyard stopper on the rope that cannot be removed:

1. Locate the end of the rope opposite of where the bottom weight will attach to.
2. Push the end of the rope through the pulley system over the larger side with the wheel and underneath the rope stopper (rope stopper should be in an open position*).
3. Pull the rope through and continue feeding it underneath the metal pin (through the handle).
4. Test the pulley on land before using it in the water.

*See the illustration below for the rope stopper’s ‘open’ position

Secondary Safety Measure

When diving, we recommend taking the remaining loose rope and secure it to a second carabiner (we recommend using the clove hitch) attached to another place on the buoy outside of the D-ring area, such as one of the handles. This will provide a backup attachment point as a secondary safety measure (see the illustration below for reference).